The engine and gearbox was removed again in preparation for the engine mounts being welded in place. I forgot to remove the gearlever..!
A few measurement were taken, The main measurement for the shortening is 11" from front of tail housing to the front of gear lever casting.
With the gearbox removed from the engine the tail housing was removed.
Beware the layshaft can stick to the housing and pull out with it.. potentially leaving all the cogs and gears rattling around the bottom of the case.. I think I saved it in time.
Now the tail housing is in the ultrasonic cleaner. ready for the hacksaw..!
No comments:
Post a Comment